Home › Forums › Drona Aviation – Drone for Education › Any Reset options?
Tagged: not working; firmware; reset;
- This topic has 4 replies, 2 voices, and was last updated 5 years, 5 months ago by Zore.
- AuthorPosts
- November 28, 2018 at 7:14 am #4001
I connected my pluto X drone to the app and I was able to use it. Then I connected to my PC. After a full flash of the AutoTakeOff code from github the drone neither connects to my laptop nor to my android app. What do I do now? Is there a reset firmware that I can run? I have tried switching it on and off.
- November 28, 2018 at 9:16 am #4002
were you able to full flash code successfully? means did you get a message saying “Firmware Flashed Successfully”
- November 28, 2018 at 9:38 am #4003
@Zore: No, I am not getting any such message.
On clicking the flash button,
I get the following image.
after which the app goes back to the home page.The percentage value does not even increase greater than 10%.
The app shows connected and the ARM switch turns on, but nothing more happens. - November 28, 2018 at 10:35 am #4004
- November 29, 2018 at 5:27 am #4005
SO I think you are not able to flash the firmware.
You can Flash firmware through Cygnus and App.
Make sure you have updated App and try to flash through app again.
- AuthorPosts
- You must be logged in to reply to this topic.