Error while flashing code

Home › Forums › Drona Aviation – Drone for Education › Error while flashing code

Viewing 3 reply threads
  • Author
    Posts
    • November 18, 2019 at 12:57 am #4292
      anuja135
      Participant

        Hi,
        Whenever I try to flash code after building, I get an error saying “Cant connect to Pluto”.
        I am connected to PlutoX through PlutoX’s wifi, but I still get this error.
        Please help.

      • November 18, 2019 at 5:03 am #4293
        Keval Ajmeri
        Participant

          Hi,

          I can give you a few points to check before flashing the program.

          1. Check if you are connected to Pluto’s WiFi through your computer for flashing
          2. Make sure that you are disconnected to Pluto through the Pluto Controller App
          3. If you are using camera module as well, make sure that the camera module is disconnected from Pluto

          If this does not help please let me know.

        • November 18, 2019 at 5:37 am #4294
          anuja135
          Participant

            My bad, it worked after camera module was disconnected. Thanks a lot for your prompt help.

          • November 20, 2019 at 10:05 am #4300
            srinath
            Participant

              cant we use camera module? why should we disconnect to make it work?

          • Author
            Posts
          Viewing 3 reply threads
          • You must be logged in to reply to this topic.